Volvo Owners Club Forum

Volvo Owners Club Forum (https://www.volvoforums.org.uk/index.php)
-   S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General (https://www.volvoforums.org.uk/forumdisplay.php?f=19)
-   -   Front suspension squeaking (https://www.volvoforums.org.uk/showthread.php?t=153566)

jonspencer_1981 May 20th, 2012 08:59

Front suspension squeaking
 
I have become victim to the dreaded wishbone bushes I think...they squeak ALL the time.

Are the bushes easy enough to replace or am I going to have to replace the whole wishbone? (not really what I want to do).

ctautos May 20th, 2012 09:15

wishbone
 
a lot of work and you need vice scafold pole change them.
befor you do give the m a good squirt of wd40 see if that help"s
short term

jonspencer_1981 May 20th, 2012 15:03

Quote:

Originally Posted by ctautos (Post 1167647)
a lot of work and you need vice scafold pole change them.
befor you do give the m a good squirt of wd40 see if that help"s
short term

Hi,

Thought it may be a fair bit of work :(

I know my steering limiters are split, but I don't think thats the cause of the issue (however, that would be reason my my wheels have all of a sudden starting rubbing on full lock)

I heard about WD40 or washing up liquid. I'll go round one by one and give a squirt to see which one is faulty, as there's no point in replacing bushes if its top mounts!

Is there a "how to" on changing the bushes, as I really begrudge paying for labour at a garage, as I am fairly competent when it comes to home mechanics.

Rover Saloon May 20th, 2012 20:34

Change bushes or the entire arm?
 
Have gone both ways and make the following observations.
Replacing the entire arm is pretty straightforward and is well documented in the Haynes manual as well as on this forum.
Changing the bushes is more tricky - you need access to a very wide opening engineer's vice - about 25cm or so. You also need some pipe that is perfectly cut at right angles and exactly the correct diameter to act as a drift to push the old bushes out. I was lucky to have access to a lathe so turned the pipe to precisely the right diameter. Forget washing up liquid/WD40; these fellas are in damn tight and need a fair bit of force to push them out. However, with the equipment I have mentioned above, I had no problem.

I replaced with genuine Volvo bushes which brings me onto the final point.

There is a hell of a lot of utter crap out there both as arms and bushes. If you decide to go the bush route, get the best - it's worth it in the long run. The same goes for the arms but you are talking about a fair bit of cash. Avoid Scanteck like the plague - utter sh*t.
Let me know if you need any more detailed advice once you have decided which way to go.


All times are GMT +1. The time now is 10:43.

Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.