timing belt failure
Hi, my 1991 940 2 litre died yesterday at a busy junction, there was no noise or drama that I could hear above the traffic noise but, after investigation the timing belt has snapped.
The burning question is..... is this engine, (I believe a B200f but could be wrong a NON interference engine? There are numerous threads I've seen on the web and, some say a red block engine is a safe, i.e. non interference engine and others saying their b200f had damage. Is it a case of strip it and look or is there a definitive answer to interference or NON interference? Many thanks Ken |
I should have said it's a non turbo engine.
I also should mention... I drove in reverse gear on the battery to get it onto the verge. Ken |
The B200F engine is, i believe, a borderline engine. Many say it's a non-interference engine but there have been others that have had valve to piston contact. However, in the majority of cases, those people also knew the head had previously been off and skimmed so reducing that vital valve to piston clearance.
Given that you were stopped at the time and hopefully only turned over on the starter, there's a fair chance you have got away with it - only way of being sure is to fit a new timing belt. Are you sure it's a B200F? Is it mechanical or electronic injection and does it have a Lambda sensor and cat or not? A photo would help if you're not sure. If it's a B200E with K-Jetronic (mechanical) injection, there's a much higher chance of there being no damage. |
Quote:
ken |
Quote:
|
Quote:
I tried jump starting it in gear then on the starter before I headed for the grass verge. I want to avoid fitting a new belt to see if its damaged the engine. sort of throwing good money after bad, as much as I like my "tank", if it's a question of remedial work on the engine, i.e. valves, push rods, even a damaged piston then I would have to get rid. kind regards ken |
Quote:
|
The B200F cat (LH2.4) is a non-interference engine as long as it is the original unmolested engine i.e., no head skimming etc. When you replace the belt also do the belt tensioner as well (come as a kit) and also water pump if suspect although you may want to leave it alone if it looks good as they can be the a bugger to seal properly if no experience.
Bob :) |
If the old beltmos now oit the way its a half hour job to slap in a new one, so for a few quid and half an hour of your time you'll know if you got away with it or not.
|
Quote:
I'll do a compression test after fitting. many thanks to all Ken. |
All times are GMT +1. The time now is 01:39. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.