[S40] Anti Skid Temporarily Disabled/off
 

First of all hello to everyone!

I recently bought an S40 1.6 Diesel DRIVe 2009
All looks good except when i drive for a while the message in the title pops up.
It will go away when i start the car the next day/after a few hours.

I've got Vida dice 2014d and got these codes:
BCM-0101
BCM-0115
BCM-0148
BCM-E000

Since i don't know for how long they've been there i deleted them today and will see if they will reappear when i drive again.

Is this something to be concerned about? I saw a similar thread on google (this forum) with no solution.

Ok, i've got an update.
I replaced the EGR valve deleted all the errors and for now there is no problem anymore, no errors drives good.

However, after replacing the valve the clamp is not as tight as it was before.
I ordered this one https://www.ebay.co.uk/itm/16283J-Ci...72.m2749.l2649 but after installing it it's not as tight either. I can rotate it without much force but won't slip out of place for sure.
Is that a problem?

It shouldn't rotate. It should be darned tight. I reused the old one without problem. Do you have a set of circlip pliers and are you sure the clip is fully done up? It doesn't sound like it.

The first time i removed the old EGR to clean it and put it back in i had no problems with that clamp. I don't have the proper pliers but its snapped in..

Also, the new clamp i bought is using a screw and can't tighten it properly either..