Technical question: missing oil seal?
I have removed the half-shafts on my 165 to replace the brake backing plates. Whilst doing this I noticed evidence of a slight oil leak, so I was paying attention to the seals.
Haynes shows an inner and outer oil seal at the wheel bearing: https://i303.photobucket.com/albums/...ed-image_1.jpg My axle has an outer seal, and a channel for the inner seal, but the inner seal is missing. https://i303.photobucket.com/albums/...6_112147_7.jpg https://i303.photobucket.com/albums/...6_112806_5.jpg So is it a simple case of a seal missed during a bearing change? Looking at the Skandix parts site, this service instruction is given: "Installation Information Volvo 140 70-, 164 70-, P1800E, P1800ES: The wheel bearing runs under differential oil and is only pre-greased during installation to prevent dry running. Do not use the inner radial oil seal. It is only supplied in the kit to be used at the 200/700 Series." https://i303.photobucket.com/albums/...106-115725.png Annoyingly, they don't say why the exact same bearing should have both seals fitted on a 200, yet not the inner seal on a very similar 100 axle. IPD sells an inner oil seal which is current on their site and listed as correct for a 1973 164. So the Skandix instruction to delete the inner seal is clearly is not universally accepted practice. https://i303.photobucket.com/albums/...106-210714.png Also, although grease from my bearing has all been washed/absorbed by axle oil, there are traces of grease in the groove between the axle tube and the end piece. This supports my view that my axle originally had a greased wheel bearing with seals both sides. On the basis of my leak, and the evidence of the axle being designed to have two oil seals, I am strongly leaning towards refitting an inner seal. But if anyone can explain the rationale of the Skandix instructions, I would be keen to hear and understand it. Thanks John |
The axles only had the outer oil seal
The inner seal was added with the 1031/1041 axles I have replaced more axle bearings by far on the late double sealed axles than on the early single outer seal type. I suspect the diff oil helps to lube the bearings rather than doing any harm |
Quote:
John |
No idea but I never trust Haynes
|
I'd lean towards having just the outer seal, too, cos of helpful diff oil prolonging bearing life, as CS says. I have found similiar situations in other machines; Stihl say 50/1 oil/petrol ratio for chainsaws, etc. After a couple yrs, u'll need new mains an piston on that ratio, as happened to me. Mechanic at concessionaires said run motor on 40:1 an it won't happen. 6 yrs later, his words have proved to be true.
While we're here, John you mentioned some engine mods that can be useful, could you outline them? Regards, Mark. |
All times are GMT +1. The time now is 08:46. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.