dog dish flywheel
Hi
I'm after a solid flywheel for my 940, looking to change from the dual mass fitted. It's for a 1994 2.3 turbo, M90 gearbox, I think it has to be lh2.4 for it to work? Thanks |
Hi
have got one now Thanks for looking |
Hello
Where did you get one from? I'm having a nightmare with a juddering clutch for the want of a dogdish in good nick? I need one for a 240 Let me know would you? Cheers Nick |
Hi Nick
Ebay was my friend on this I did not have one at all I needed one to fit to a 940 turbo that is going in the 240 if your clutch is juddering just have the flywheel skimmed take say 1 mm or till its flat dont forget to have the ears that stick up that hold the presser plate skimmed the same amount as well let me know if you need more help with this |
Hi Grumpydad
Thanks for that A local gearbox specialist has tried skimming two flywheels for me to no avail - they say that the surface is so hard that it just throws off their cutter and because the surface is recessed they simply couldn't skim the flywheels properly! So the car is driveable, but as soon as you use any revs to move off or you reverse, the clutch judders - in reverse you get a sort of booming from the propshaft too... Short term I can live with this, but it's not good longer term So I am a bit lost at the moment - going to call Dai at Classic Swede in the next day or two. Unless you or anyone else has a better idea? Nick |
Hi Nick
just had my flywheel skimmed thay did a great job I am in Hastings so is the shop can give you the address if you want |
I'd appreciate the address too- I might need a flywheel skimmed...
Cheers |
|
M90 gearbox conversion
I am converting from a M46 to a M90 gearbox on a 940 2.3Ft. My local Volvo dealer does not show a pilot bearing or spigot bearing for the clutch input shaft in his data base.
Am I correct in assuming that there is a required pilot bearing for the M90 and that it is likely a different shaft diameter that the M46 gearbox? |
Hi
yes you are right the M90 is bigger if you want some sizes let me know but please ask this in the general section thanks |
All times are GMT +1. The time now is 17:58. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.