B200F cylinder head -- a cry for help!
My old faithful 1994 940 Wentworth LPT has overheated and warped its cylinder head. The garage (who I trust) have pronounced the head too warped to be repaired; that may well be because it was previously skimmed after a very severe overheating episode many years ago. So I'm now in urgent need of a cylinder head, whilst also not being knowledgeable as to which heads will be suitable. Does anyone out there have a straight head for sale, or one suitable for reconditioning? Many thanks in advance.
|
Hi,
l have a complete Wentworth engine sat outside my workshop, l altered the back of a Peugeot at a roundabout many years ago and sadly broke the car. lt has been covered up and l see no reason why it should not do the job although l've had some of the manifold studs, l'm a bit reluctant to split but for the right reasons l will consider it. You see....... l still run a Wentworth and parts are getting difficult, also bear in mind l'm in WR11 7PD area for collection if need be. Andy 07730387598 |
Could just be a lifesaver. I've tried to phone but you weren't about -- when's a good time?
Phil |
Quote:
had to deal with my grandsons Fiesta this afternoon and left my phone on the bench. Anytime is OK to be fair just ring again and l should answer, l could ring you but it's getting late now and l never invade peoples nocturnal habits!!!! |
Just to follow up -- the car is back on the road with a replacement cylinder head, and running nicely. Many, many thanks to Andy for the necessary.
|
Brilliant ... :)
|
Quote:
This Forum is such a game changer for so many Volvo enthusiasts and l was glad to be of some assistance (anyone looking for a 200FT Block in good nick without a head?) Phil l hope the head continues to give good service for many years to come........ Happy Motoring.....Regards Andy |
Quote:
|
Quote:
But then the car was recovered to Ashford, where the water pump and pipe were replaced and _then_ they told me the head gasket was 'weeping a bit'. They thought it would probably be OK to drive it carefully back to base (about 60 miles) where I could get it looked at. In fact I got only a short distance before it became apparent that it wasn't happy at all, and the journey was rather fraught, with frequent stops. It did stay out of the red, but was a fair bit hotter than it should have been -- but it wasn't obviously worse at the end than at the start of the journey. Nowhere near as dramatic, though, as the previous overheat, some twelve years ago and not long after I bought the car. When I acquired it, it didn't have a functioning temperature gauge, and I foolishly didn't immediately replace it. I didn't notice the overheating until it started making odd noises and losing power. On that occasion it melted the timing belt cover, so I think we may assume it got quite hot... I think that probably explains why the head couldn't be skimmed a second time. |
Quote:
A Boss at work had a brand new 760 V6 back in 1982 , his secretary went somewhere in it and drove it until it would drive no longer , all the coolant had gone for some reason , the engine got so hot that all the wiring and plastic bits melted on top of the engine ... |
All times are GMT +1. The time now is 02:23. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.