Volvo 340 CVT
1 Attachment(s)
The yoke holding the release bearing on my volvo 340 CVT automatic have slipped of on one side (check picture) Do I have to remove the flywheel housing to fix this problem or is it enough to disassemble the driveshaft where it meets the flywheel housing in order to fix this problem?
|
Quote:
|
Plastic arm pivot cup? Do you mean the plastic shield underneath the yoke?
I am from Norway so my english is not that good. |
Quote:
|
I am not sure tbh, it might be. I know that one of the yoke arms around the release bearing is loosened up. When removing the bellhousing, can I do it with only car ramps? Or do I have to remove the engine completely?
|
Quote:
|
you will need to support the engine
|
great wee car done hundreds of clutches on this model shimming them as well
good luck regards |
All times are GMT +1. The time now is 23:21. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.