Crank sensor bracket
 

Howdo all,,so I'll put this up,,just so u no.so got in my car turned the key,did not start...!!??..so stuck my autel al319 in diagnostic port,,,P0502 and P0336 came up,,not bothered to much about the first one,,,its maybe a ABS sensor (hopefully) ….the P0336 crankshaft position sensor A circuit range/performance is now hopefully sorted as soon as I charge my battery (again hopefully) it just died from trying to start it,,,and I've heard these cars don't like low battery power..!!!,,,,its the bracket that was my problem as wen I put on new cranksensor on it,,it desolved into bits..!!!!!..so replaced the £25 bracket which is a PITA and got lucky,, will put up sum pic of it ,,got at one bolt ok,but the bolts behind the little aluminum block by chiseling a little bit of the 1in by 15mm aluminum block off and useing a smaller torx bit to the bolt.to get in to the torx bolt so to give me a little bit of a angle movement and it worked,without taking so much more stuff off just to get to that bracket,,so if u ave this job to do hope it help...

Is this in the rear of the engine or the front? I can't "see" where it is.

Hi. So if u standing in front of car in front of engine its on ur right a little bit,, down were the engine block meets flywheel casing 2 wires coming out of it...

So I put a charge battery back in car turn the key and nowt,,turned over but no start,,,so check the wireing going to new cranksensor ,continue test=good earth but nowt,!!!!..so if any body got a wiring diagram for a 2002 v70 2.4T,,B5244T3 engine as I can not see were the wires go or any suggesting... Manythanks..