Dog Guard Gas Struts
Hey all,
I am after a little bit of help. I'm trying to replace the gas struts that hold up the dog guard in my V50. I have ordered and received a set of replacements from a company that confirmed they would fit. They appear that they should. However I can not seem to figure out how to removed the old ones. The Old ones have part number - 30664236 They have the ball joint ends, but do not have any type of retaining clip that you would normally remove before popping them off. Link to Photo - https://photos.app.goo.gl/Dgt2EkEsuXhN2BuE9 Any ideas? |
Any ideas anyone? before i use brute force and make a mess of it?
|
A small amount of wd40 or another lube and pop off brute force I think 🤔
|
I think you may be right. Just wanted to make sure there wasn't a simple way of doing it, that I hadn't thought off!
|
Did you get them off in the end?
|
Hey,
No didn't get them off as they were press fit joints. Apparently there is a old dog guard that has press fit ball joints and a newer one that has a release pin, similar to the design of the V70 dog guard |
All times are GMT +1. The time now is 11:39. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.