jasonb |
Sep 11th, 2012 17:38 |
take the headlight out of the bumper assembly by removing the single metal bar at the rear.
Disconnect the wiring harness.
Twist open the round plastic disc on top of the housing.
You can see two wires going in to the sidelight socket.
Pull on them from above but in the direction going towards the back of the lamp.
The harness should come out with a little force.
Re-fitting is the reverse.
One point of note, if using something like the LED's that I have, sometimes the LED's fall out of the socket when removing and end up inside the reflective section. Bit of a pig to get the bulb out after that but not impossible as It's happened to me twice before.
Good luck!
Oh, one last point, the bulb should be test fitted before re-inserting in to the lamp housing. LED's are "sided" and only work one way around on the pins.
J
|