B230ET 3 Inch exhaust from stock downpipe ?
Hello Everyone,
I've been looking for a 3 inch stainless steel down pipe for the car but i can't seem to find one, I can only seem to find standard size stainless downpipes from skandix. So would i still see a benefit in performance if i used a 3 inch system from a standard down pipe. Thanks Jack |
Depends what other mods you've got. If you haven't got any other mods, chances are you'll just make it noisy, thirsty and slow. THere's a lot of good exhausts around with a 2.5" bore or even slightly less that will give you a nice note and an improvement in power and economy.
|
If you just want a downpipe https://www.classicswede.co.uk/940_t..._18337088.aspx
for under 350BHP there is no point in 3 inch and you would be better off with a 2.5 inch system |
So around 280 Bhp theres no need for 3". 2.5 hallway througj is sufficient enough. ?
Thanks Dean |
2.5 inch will do what you need. Going to 3 inch will just make more noise
|
I just got a longlife fitter to make one with a cat and rear box only for about £550 was a while ago though.
The main difficulty is the Turbo mating flange and clamp, so try and buy an ebay weld on flange. It needs to be slightly smaller than 2.5", can't remember the exact dimension. I still don't have a clamp solution other than old Volvo ones (which are usually in good condition). |
Quote:
|
Does anyone know where I can find a flange for a 16 t turbo to make exhaust. ?
|
Quote:
|
Thanks pal
|
All times are GMT +1. The time now is 17:15. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.