Hi I got stuck on this earlier this year. I went out and bought a 1/4" drive wrench and put the torx bit into a small socket. There is just enough room to get one in between the tensioner pulley and the bulkhead. BUT, even though I thought ,at 20 quid for the wrench I'd got one good enough......no! I found the 'head' was a bit wobbly and when trying to get a purchase on the bolt, the head went at an angle & I was scared of knackering the torx bolt head.
So I gave in and called my mobile-mec out.
He had a far, far better quality 1/4" drive wrench and had it out in a jiffy & left me to carry on.
Good luck.
|