[ShadeTek]

I found the issue with my alarm module. I was getting constant alarm module warnings everytime I stared up and even got the alarm going off one morning. I took it to bits removing all the silicon I had used to seal it all back up which took a while. As it opened water poured out and after inspecting the pcb there are even green crusties. Obviously not sealed enough, so if you are replacing your cells, make sure you seal it tight and when refitting it, tilt it down as far as you can so any water will run off the module. I fitted a module from eBay which continued to display alarm system needs service even though Vida said, no problem. But the error cleared after an hour or so.