Quote:
Originally Posted by Laird Scooby
Great work there Luke!!! 
If memory serves, a 22 or 24mm socket will support the drop link eyelet and a size a couple of mm smaller should push the rubber out and the new one in with a bit of silicone grease to help it slip in nicely.
Either use an M12 bolt through the middle of the two sockets or use them as mandrels in your press. |
Thanks Dave, I try to stay away from using sockets as press tools as they're very old (Kamasa) that were my great grandads so I'm a bit protective of them if only for sentimental reasons! I'm still very annoyed about the 2004 Bentley Continental GT I did a wheel alignment on that was so rusty it broke my 18 and 21mm sockets when the nuts cracked off with a bang.