Quote:
Originally Posted by morsing
Those are the points I tried to use and they buckled!
|
That point is actually in sort of three sections, one is reinforced with a second piece of metal behind. If you look it's where there's a hole you can put your finger in. You can also tell by knocking on it. I found this out the hard way by buckling part of it too!
For the front I jack on that point and put axle stands further in on the engine subframe bolts
For the rear I jack on the reinforced sills then support immediately behind on a similar reinforced section with a hole. I find the rear far easier to jack/support.