Quote:
Originally Posted by jonnyf90
My 960 is a mk 2 so has the fwd offset of 43? Wouldn’t think it would be such a challenge.
Looks like the 25mm spacers on my 25 offset 940 and a set of canistos was a whole lot easier 🤣
Cheers
|
In that case you'd probably get away with 6mm spacers but you're right on the edge of the spigot in the centre of the hub so you may still need hubcentric spacers. It's the spigot in the centre of the hub that holds the wheel on centrally - the nuts just stop it falling off, no centring action.
You could try using a load of washers on 3 of the wheel studs to work out what thickness you need. You'll need M12 washers as the studs are M12 x 1.5 thread. Once you've found the minimum amount of washers needed to get the clearance you need, measure the thickness of them and that will be your wheel spacer thickness.