Macklii
Many thanks
SCW
Up the side to the nearside of of the car. Pull conduit gromment out of bodywork. Ths is held by rectangular plastic clip which remains in the bodywork.. It is loose but retained by 4 'claws'. Using a couple of thin screwdriver ease 2 claws inwards to allow half the clip to come out slightly then wiggle it out. The slighty buttuck clinching bit is over🤗. Using a length of curtin wire as a pull through ease your cable through conduit and ini the tailgate. You can then pop the wire out where you want it with the absolute minimum of wire showing and no gap to bridge when tailgate open. Putting the grommet back is simple as you can pre-assemble it and the clip
Good luck
Frank
|