Ok so had to start somewhere, so ive replaced the "steering angle sensor", being as this is a circuit board, set inside the rear of the column switch assembly, I replaced the complete item, switches, SAS and clock spring cable.
so now the bad news [inevitable really] still have the error codes, still has the "anti skid service" message on the warning panel.
now when running a diagnostic, can anyone put any light on these codes?
bcm- 0111 communication between control units SAS tolerance not yet completed......how do you do this>?
bcm-a031 communication between control units tolerance control for SAS not run.? again....how do you do this check?
bcm -0094 communication between control units communication problems with DEM.?
sorry for the questions, but I work in a hospital and have little spare time currently, as I hope you can appreciate, so any advise would be greatly appreciated, as usual guys.
