Quote:
Originally Posted by CNGBiFuel
So, where A1 to A6 is the front plug pins, and these the colours going into the front plug...
Swap A1 (BL Blue) to A2 (SB Black)
Swap A2 (SB Black) to A1 (BL Blue)
Swap A3 ( W White) to A5 ( GN Green)
Swap A4 (BL/W Blue/White) to A6 (BL/GN Blue/Green)
Swap A5 ( GN Green) to A4 (BL/W Blue/White)
Swap A6 (BL/GN Blue/Green) to A3 ( W White)
|
Just joined the forum to say a quick thank you to CNGBiFuel. I've just done this mod to use a cheap LHD cluster and it works brilliantly.
IMO it's possible to misread the instructions depending on whether you assume that the first wire mentioned is loom or plug end. This wouldn't matter for A1 and A2 but would end up in a different wiring for A3-A6. Maybe I was just overthinking it... But to clarify:
Swap A1 (BL Blue) from the loom goes to A2 (SB Black) on the plug
Swap A2 (SB Black) from the loom to A1 (BL Blue) on the plug
Swap A3 ( W White) from the loom to A5 ( GN Green) on the socket
Swap A4 (BL/W Blue/White) from the loom to A6 (BL/GN Blue/Green) on the plug
Swap A5 ( GN Green) from the loom to A4 (BL/W Blue/White) on the plug
Swap A6 (BL/GN Blue/Green) from the loom to A3 ( W White) on the plug
Also, on mine there were two blue wires in the blue socket, both are swapped together.
Here's a photo of mine.
Thank you again to CNGBiFuel!