Hi Paul
the boot pin is pin 24 not as I put before
the ecu you have is a EDC15C11
you only need MPPS V13 (clone)
info on this site, I does show the boot pin on the other side of the ecu, you may find that one better for soldering to,
http://blog.obdii365.com/2018/04/09/...tag-or-fgtech/
Have you got a site that I can upload the software so you can then change maps in the bin file,
any changes you do in the file you will have to re-write the original
checksum, you can do this in the MPPS software, if you don't do this the car will not start,
when you read the ecu in boot mode, if you do t with the ecu in the car, you will need to connect a good battery charger, as you do not want any voltage drop, you will want a 15-20amp one for this, I did measure it wheni was flashing in the car and it was taking 15amps,
Dave