Well I decided to crack on with the job and oh my what an absolute pig of a job in the most awkward place with no space. Even had to resort to putting hot glue on the torx so I could get the screws started without them dropping as it’s that deep!
So unit replaced and so far so good, error memory cleared and no active codes after a few test runs and stop / starts.
Oh and no programming either. See photo of the unit I took off where the washed was sitting on the impeller housing where it’s supposed to be on the shaft between the housing and clip, worn and has come adrift and the magnet must have kept it from going further into the system.
Fingers crossed I never need to do one of them again.
|