Volvo Owners Club Forum - View Single Post - S60 Body/Trim:

lsv · Mar 18th, 2010, 19:13

Hi,

Just replaced RH front fog by removing bumper- very useful guide but posting the following as i noticed a few differences. '02 S60 (winter pack)

Both rubbing strips removed with fingers
2x 12mm bolts removed
6x push out plug things above grill
On each side, I had an additional plastic/nylon nut and bolt/screw on the bottom corner of the horizontal part of the bumper (just before the wheel arch). Think this was a 10mm nut and the bolt had a slot for flat head screwdriver.
To remove headlamp wiper arms, first pull off the washer tube. at the bottom of the arm, where the hinge mechanism is, there is a cover which flips up to expose a 8mm nut. Undo this completely then pull of the arms - mines required a bit of persuading :-)
You should now be able to remove the bumper.
Once exposed, the fog is held in place by three torx 25 screws. remove. There is a locking mechanism for the cable - push the metal catch in and remove the cable from the back of the lamp.
Fit new lamp.
When putting bumper back on make sure washer tubes are put through hole in bumper first!

Hope that helps someone!

Mar 18th, 2010, 19:13	#22
lsv New Member Last Online: Aug 21st, 2017 18:59 Join Date: Nov 2004 Location: Edinburgh	Fog Lamp Done - but with wipers Hi, Just replaced RH front fog by removing bumper- very useful guide but posting the following as i noticed a few differences. '02 S60 (winter pack) Both rubbing strips removed with fingers 2x 12mm bolts removed 6x push out plug things above grill On each side, I had an additional plastic/nylon nut and bolt/screw on the bottom corner of the horizontal part of the bumper (just before the wheel arch). Think this was a 10mm nut and the bolt had a slot for flat head screwdriver. To remove headlamp wiper arms, first pull off the washer tube. at the bottom of the arm, where the hinge mechanism is, there is a cover which flips up to expose a 8mm nut. Undo this completely then pull of the arms - mines required a bit of persuading :-) You should now be able to remove the bumper. Once exposed, the fog is held in place by three torx 25 screws. remove. There is a locking mechanism for the cable - push the metal catch in and remove the cable from the back of the lamp. Fit new lamp. When putting bumper back on make sure washer tubes are put through hole in bumper first! Hope that helps someone!