Quote:
Originally Posted by Clan
you need to fit a new Loom connector to the injector , You have started at the wrong end of the chain ...
first item should have been connector , second the injector and third ECU ( ECU is always very last on the list )
Two of these 30765319
you will need a very thin tool/screwdriver to release the terminals from the housing .
|
Great, thanks, Clan.
What is the logic to a 'Signal too high' message being caused by a dodgy connector, which I normally associate with low voltage being passed.
Is the ECM having to pump out more electrons to overcome high resistance?
Cheers
Joe