[burchi]

Hi Patrick

On my '98 R AWD, Longlife put on the following..

Joined onto the 2.5" post CAT another 2.5" pipe through and over the rear axle where a Y-Piece was fitted being 2.5" on 1 section and then 2 x 2" on the other sections and from this came 2 lots of 2" pipe through to both silencer boxes and finished in 4" tailpipes (rolled in).

You will get a bit more noise generated courtesey of the larger diameter pipework and you may want to consider a small freeflow silencer box shortly after the CAT to help reduce this. I didn't have this and it was a little drony at 2,500 - 3,000 RPM but not nearly as bad as it had been with the TME system I had on beforehand!

Hope this helps

Regards



Ian