Hello all,
Quick info for you if you are looking to change brakes by yourself in V90 D4 MY20.
After you get the correct parts from any shop you normally use make sure that you have too.
- T30 Torx bit for Disc screw. 10Nm to screw it back.
- 7mm hex bit drive 3/8" for 2 caliper slide screws. Same size front and rear. 57Nm force to screw it back.
- 18mm Socket 1/2" drive for Front caliper bracket. 200Nm.
- 15mm socket 1/2" drive for rear caliper bracket. 120Nm.
- Caliper push tool.
- 9V battery for winding your rear brakes.
I found out that my car get DTC on ABS after I winded rear brakes.
- C20071B - General electrical failure of the right motor
- B111167 - Electric parking break enabled. incorrect signal after the event.
There were no driver assist available like speed limit or pilot assist.
Since DTC removed all is great. Have this in mind when replacing brakes.
One more thing to say there is no vibration during driving or under braking, I would say the vibrations have gone that I had previously when I was going with speed between 80-90mph.