It mentions somewhere in my Haynes Manual about a re-learn for all X40s. If i can find it ill write it down
ok the manual says, To allow the ECU to learn running values,
1. Start the car and hold as close to idle speed as possible until operating temperature is reached.
2. hold at 1,200RPM for approx 2 minutes.
3. take the car on at least a 5 mile varied drive to allow the ECU to finish the relearn process.
This should be sufficient for the ECU to relearn the running and idle values.
Last edited by V40Vinnie; Apr 26th, 2017 at 21:20.
|