Thank you Gatos for being so very helpful. I really do appreciate it as I am sure we all do on the forum.
I have just removed the top trim and the item is coloured black so presumably phase 1. Also the buckle has the one square hole.
2 more photos attached.
Actually, with the trim detached, I can make the belt coil back up, but then it is a real pain to pull back out. Just taken me half an hour.
So, the belt is now adjusted perfectly for me again and a strong clip attached on it to keep the setting.
To remove, presumably 1 large bolt at top, 1 bolt below and then a domed bolt which holds the pyro cylinder. I think all torx fittings.
I need a working phase 1 or early phase 2 drivers seat belt. Preferably not frayed although I could swap it with my webbing.
Can anyone help please ?
|