Yes I have them, but not on my laptop. I am sure others will be able to give you a full rundown b4 I get there!! Have you got Haynes 2003 edition for the 700 Series it gives you some. Have a look at FAQ's above there are quite a lot there.
FYI - Although you might be reading a speedo fault it ain't necessary so. You are only say a few rpm above the norm 700/900rpm range. Blip the accelerator a few times and squirt some WD40 on the cable at the roundall in the engine bay. If no joy I would suspect the problem is a slightly gummed throttle valve ( again see FAQ's).
P.S. The blue wire? Can't recall that off the top of my head. Blue multi-pin plugs yes. Assuming you have a VDO cluster and the speedo needle is working you are getting a signal from the diff sender. So if there is a signal failure it will be from the back end of the cluster to the ecu. So pull them all again and clean with some switch cleaner.
Last edited by bob12; Apr 16th, 2018 at 18:50.
|