Hi Paul,
Yes we did meet at the NEC, I mentioned the injector servicing kit to you.
Just at tail end of repairing (adding right hand side piece and fixing bracings that side, similar on the left but at least I had the partially rotting one in place this side) the boot floor and ends of chassis legs. Got 1 metres of the chassis channel made up against an original offcut for £15, got to be better than me hammering one out.
Now my questions.
Are there any holes to be drilled in the right hand side (beyond wheel well) floor panel and if so where and for what?
I see 2 holes in the floor (within wheel well) one each side just aft of the drilled out spot welds for the rear balance. Are these likely to be the holes for the drain tubes?
I attach some photos for your sympathy, I have made a solid start and things are becoming more stable as I work.
Thanks,
Ian
|