View Single Post
Old Nov 19th, 2017, 19:55   #11
Ron Kwas
Premier Member
 
Ron Kwas's Avatar
 

Last Online: Today 21:58
Join Date: Jul 2007
Location: Connecticut, USA
Default

GUS;

I have to agree with Kay, about possibly bent Upper Control Arm (...bottom surface of it should be in one plane)...although that picture is not straight-on, which could add some perspective error, there does seem to be an angle:

..this results in Upper Ball Joint pointing a bit to the rear, but thankfully, because it is a ball joint, this is not a huge issue...this will affect Alignment a bit (it might even be possible to align it out)...if I had an UCA which was lightly misformed like that, I'd replace it...OR... fixture it up on a 20T Press, and bring it back to nominal shape, and inspect for cracks with fluorescent penetrant before installation, just to be sure no cracks developed from bending operation...

I don't see any issue with Anti-Roll-Bar...again, perhaps whatever Russ is seeing, is introduced by camera-angle...

Good Hunting!

Last edited by Ron Kwas; Nov 19th, 2017 at 21:44.
Ron Kwas is online now   Reply With Quote