Quote:
Originally Posted by Bigfella666
Chaps
I am on the hunt for urgent help yet again !
For those of you who have been laughing at my woes I managed to get the new belt through and on to the bottom pulley in 2 mins.
Trouble now is despite routing the belt correctly it is too short to fit onto both exhaust cams and I am lost for an answer ! I made a drawing pre removal and confirmed with Robert DIY
The obvious answer is that the belt is not quite sitting on the bottom sprocket but it appears to be once I get my hands past the aux pulley.
I am 99% sure I checked the length of both belts but confirm the markings are the same. The pin remains in place on the haudraulic tensioner.
HELP PLEASE !!!!!!!!
|
have you got the belt above the projection at the bottom of the crank pulley toothed wheel ? also i assume you have compressed the tensioner and pegged it in with a 2mm pin ? A steel pop rivet stem is a good thing for this .