Step 17 - Grab the gear linkage arm and slide it back over the bush (it will be a slightly tight fit)
Step 18 - Try to align the holes with those in the bush as close as you can (don't get too carried away though!). You can see that my car is due a bit of a clean here
Step 19 - Use the bolt from the underside as shown in the picture to make sure you get everything in alignment. Whilst pushing the screw up from beneath you can manoeuvre the gear linkage around until it all slides into place
Step 20 - Once aligned, drop the bolt in from the top and tighten the 11mm nut on. This is done in the same way as early using the 11mm spanner on the top also
