Rear windscreen trim
OK, so hopefully there are three photos attached which show the cable (I used cable about a quarter of an inch in diameter) that has to be wedged into the rubber trim channel of the windscreen seal to lift up the lip. The bright trim is then placed on top of this, pushing it into the lip and pulling out the cable at the same time. This is quite easy if it is the original bright trim that is going back into the original rubber surround. However some time needs to be spent straightening the trim out and the gap that the rubber lip fits into to get the shape perfectly symmetrical with the windscreen rubber. I noticed in the photo that your trim was bent out of shape, so you are going to have to straighten that out first, or it just won't fit. Regards Tony.
|