|
140/164 Series General Forum for the Volvo 140 and 164 cars |
Information |
|
Changing girling brake pads 69, 144.Views : 206 Replies : 3Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 23rd, 2024, 13:46 | #1 |
arcturus
Last Online: Today 08:20
Join Date: Mar 2006
Location: Sagres Portugal
|
Changing girling brake pads 69, 144.
After 15 years ownership it's still not something I have done. any advice,tips etc would be appreciated. Is there a problem keeping the pistons off when pads removed?
__________________
life's too short to drink bad wine |
May 24th, 2024, 21:13 | #2 |
VOC Member
Last Online: Today 15:05
Join Date: Mar 2008
Location: Northampton
|
In the absence of any other replies:
I'm not sure about the fronts as it is 45 years since I had my 145S, however, my C70 has the exact same calipers on the rears. I punch out the holding pins and remove the spring clip, then gently prise one pad away from the disc and remove. I then give the brake pedal two full presses to activate the piston - this proves that the piston is free and an opportunity to check the rubber bellows. I then crack off the bleed nipple and press the piston fully back - catching any brake fluid in a container. Once the piston is fully retracted I clean up the pad slides, lube the pad with ceramic grease and refit in the caliper. I then repeat the same process for the other three pads, checking the fluid level in the reservoir as I go. Once all pads have been refitted, I refit the pins and springs. Depending on the pads the anti-squeal shims may be loose or attached to the pad, if loose carefully refit and line up with the pad. All very straightforward and a job I do every year as part of the MOT yearly service.
__________________
2001 V40 2.0lt Sport Lux - Daily Driver. 178k miles. 2003 C70 2.4 GT Convertible - Garage Queen. 67k miles. http://www.neptuno6benagil.com |
The Following User Says Thank You to ITSv40 For This Useful Post: |
May 25th, 2024, 13:05 | #3 |
Senior Member
Last Online: May 25th, 2024 14:04
Join Date: Sep 2019
Location: heptonstall
|
Do be careful not to get any grease (copperease) on the pads or discs, just a smear on the pad seat areas, which are right by discs. .
|
Today, 11:16 | #4 |
VOC Member
Last Online: Today 11:16
Join Date: Jul 2006
Location: Chatham
|
If your old pads are very thin, the pistons will have to retract a long way to allow the new thick ones to fit. If your brake reservoir is full this piston movement can cause them to overflow. Remove some fluid with a syringe or turkey baster before starting the job. After completing the changeover, now is a good time to replace the old fluid with new. First job is to soak all of the bleed nipples with a good penetrant. Make sure they come out OK. Buying a new set beforehand is a good idea.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|