|
850 / S70 & V70 '96-'99 / C70 '97-'05 General Forum for the 850 and P80-platform 70-series models |
Information |
|
Weld Crossmember - need garage jig?Views : 532 Replies : 4Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 25th, 2013, 09:12 | #1 |
New Member
Last Online: Feb 26th, 2013 18:55
Join Date: Nov 2011
Location: Bath
|
Weld Crossmember - need garage jig?
A rear crossmember is rusty on my Volvo 850 GLT, I was told it wasn't too bad, could be welded, can anyone tell me if this weld job needs putting up on ramps/jig in a commercial garage or can be done in the back yard?
Cheers, Steve |
Feb 25th, 2013, 09:35 | #2 |
Premier Member
Last Online: Nov 5th, 2014 09:53
Join Date: Jul 2009
Location: Telford
|
I would imagine you would only need a jig if said cross member has actually fallen off!
Assuming it is still attached in its rusty state, simply re-weld it
__________________
SHOULD ANYONE BE OFFENDED BY ANY OF MY POSTS THEN IT SERVES THEM RIGHT FOR STICKING THIER HEAD ABOVE THE BARBED WIRE FENCE THAT IS LIFE ! |
The Following User Says Thank You to GMad For This Useful Post: |
Feb 25th, 2013, 09:52 | #3 |
New Member
Last Online: Feb 26th, 2013 18:55
Join Date: Nov 2011
Location: Bath
|
thanks for that. Rather than get a garage to do it in house I could get a (competent) friend to do it then I hope.
|
Feb 25th, 2013, 12:55 | #4 | |
Premier Member
Last Online: Nov 5th, 2014 09:53
Join Date: Jul 2009
Location: Telford
|
Quote:
If you were a little nearer to me, I'd do it for you
__________________
SHOULD ANYONE BE OFFENDED BY ANY OF MY POSTS THEN IT SERVES THEM RIGHT FOR STICKING THIER HEAD ABOVE THE BARBED WIRE FENCE THAT IS LIFE ! |
|
Feb 26th, 2013, 07:40 | #5 |
New Member
Last Online: Feb 26th, 2013 18:55
Join Date: Nov 2011
Location: Bath
|
Well ta anyway! I'm going to get MOT test done(tomorrow) at my helpful regular garage and they will I'm sure let me know how far gone it is.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|