|
S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General Forum for the P2-platform S60 / V70 / XC70 / S80 models |
Information |
|
Power seat stuck full forward!Views : 6570 Replies : 18Users Viewing This Thread : |
|
Thread Tools | Display Modes |
|
Feb 2nd, 2014, 12:33 | #1 |
Senior Member
Last Online: May 3rd, 2024 10:50
Join Date: Feb 2008
Location: devon
|
Power seat stuck full forward!
Hi,
I've been trying to fitt heated seats in my 04 V70 following mikealders guide. http://www.volvoforums.org.uk/showthread.php?t=192878 I've now spent a day and a half doing it (very hard job on your own!!) and have bloodied and bruised hands to prove it! So far i have the heat pads in and all the wiring fixed to the seat. Todays job was to put the seats back in and wire the heater pads up to the volvo heated seat wires. Long story short i've cocked it up a tad. Problem 1: I managed to remove the drivers seat in full forward, now i cant get in to bolt it back!! Had to plug the seat in to try and power it up and move it back but the seat wont work. Not sure i how the best way to trace a fault on the power seat is? Ive checked the fuses and have a multimeter but not sure where to start. Problem 2: in trying to resolve the above i turned on the ignition causing the car to throw an airbag fault as the passengers seat was in the lounge at this point.. More haste less speed i know.. Not sure if this airbag service warning could disable the seats? Any advice GREATLY received. Thanks Chris |
Feb 2nd, 2014, 12:44 | #2 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
Which wires did you cut in to for the power to the seat heaters, I did state which ones to use at the end of the guide but lets start by checking what colour the wires are that you have cut. The reason I want to check this part is the guide I wrote covered an S60, the V70 might be slightly different.
As for the SRS warning, yes powering the car up with a front seat in the lounge is enough to trigger the SRS light, you will need someone with Vida/ DiCE to reset that for you once the seats are both back in. |
Feb 2nd, 2014, 12:51 | #3 |
Senior Member
Last Online: May 3rd, 2024 10:50
Join Date: Feb 2008
Location: devon
|
Thanks for the reply.
Wires i've cut are the blue with red stripe and black. I have ruled these out for causing the problem as there was nothing connected to that plug to start with. |
Feb 2nd, 2014, 13:01 | #4 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
I have checked the V70 diagrams and the seat heater wiring is the same so at least the two wires you have cut are indeed the correct ones to feed power to your new seat heaters.
For the power drivers seat there are two fuses 11C/3 and 11C/24 so worth checking both these fuses with a meter. If you have an electrically powered passenger seat it only has a single fuse 11C/4. To be honest I would get both seats back in the car then try to motor them back with the engine running, the SRS light won't stop the seat motors from working - Mike |
The Following User Says Thank You to mikealder For This Useful Post: |
Feb 2nd, 2014, 13:26 | #5 |
Senior Member
Last Online: May 3rd, 2024 10:50
Join Date: Feb 2008
Location: devon
|
Ok,
So i have now powered the seat rails back using a power pack connected directly to the motor. At least i can bolt them back in as you have said!! Have also checked the relevant passenger compartment fuses as you say with a multimeter this time. All fine there. Going to give the wiring underneath a look over then bolt everything back in and try again. |
Feb 2nd, 2014, 13:38 | #6 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
If you have had the side of the seat off did you remember to reconnect the electrical connector from the switch pack in the side of the seat, easy to forget but if it gets left off the seats won't move at all - Mike
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|