|
PV, 120 (Amazon), 1800 General Forum for the Volvo PV, 120 and 1800 cars |
Information |
|
Oil filter will not unscrewViews : 1053 Replies : 10Users Viewing This Thread : |
|
Thread Tools | Display Modes |
|
Apr 29th, 2017, 16:15 | #1 |
Junior Member
Last Online: Sep 9th, 2021 16:53
Join Date: Sep 2014
Location: Walliswood
|
Oil filter will not unscrew
Any help or suggestions will be much appreciated.
Try as I might, I cannot move the screw on Volvo white canister oil filter on my B18 Amazon. I have spent 3 frustrating hours with a strap wrench (bent the canister out of shape) a chain wrench (scraped the canister but still will not move) and oil filter pliers. Plenty of WD40 was also applied. Because of the limited access there just doesn't seem enough room to really give it a good twist. Short of removing the inlet and outlet manifolds, I can't see what to do next. I have not punctured it (yet !) Does anyone have any suggestions for me ? Thanks, Mike |
Apr 29th, 2017, 16:19 | #2 | |
1800necwinner
Last Online: Yesterday 20:47
Join Date: Oct 2008
Location: East Anglia ,Suffolk , uk
|
Quote:
The Key To It Is GRIP and that magic losen turn ! Plus better access is from below sometimes I find but is easier said when you have a four poster ramp . Good luck mike Kind regards Robert.w
__________________
I grew up on classic volvos hence my passion for them born and breed into the lifestyle ! Last edited by 123GT-AMAZON; Apr 29th, 2017 at 16:24. |
|
The Following User Says Thank You to 123GT-AMAZON For This Useful Post: |
Apr 29th, 2017, 18:07 | #3 |
VOC Member
Last Online: Yesterday 14:25
Join Date: Jul 2006
Location: Chatham
|
This type of removal tool works, grips well. Yes bashing a big screwdriver through it works as long as you don't mind the mess!
http://www.ebay.co.uk/itm/TOOL-REMOV...cAAOSwLnBX3JYn Should be hand tight on and hand tight off. Oil the sealing ring well. Yes, always harder to get off when warm, so loosen by hand if you can when cold and then retighten a bit before warming up the oil before draining. |
The Following 3 Users Say Thank You to Derek UK For This Useful Post: |
Apr 29th, 2017, 18:45 | #4 |
Junior Member
Last Online: Sep 9th, 2021 16:53
Join Date: Sep 2014
Location: Walliswood
|
Thanks Robert and Derek.
I tried the fan belt but nothing unscrewing that way either. I've ordered that tool you suggested Derek, and will see how that goes before resorting to a screwdriver. One of the most frustrating afternoons yet......and all for an oil filter ! |
The Following User Says Thank You to MikeKiernan For This Useful Post: |
Apr 29th, 2017, 21:17 | #5 |
Master Member
Last Online: Yesterday 20:39
Join Date: Dec 2002
Location: Alton
|
Suppose the filter is so tight that if you were to punch a screwdriver through it and it still doesn't turn?
A method which has worked for me for many years of messing around with spin-on filters is to use a large jubilee clip on the filter and tighten it hard, close to the engine block. Then with a long screwdriver with the blade which extends through the handle, or other suitable drift, place it against the jubilee clip screw head and tap it with a hammer until the filter turns. After the filter has turned a little, re-position the clip to get a better purchase for the next series of hammer strikes. You may have to do this several times before the filter gets loose enough to turn by hand. It demands patience, but is a cheap way of getting you out of trouble without the need for expensive tools - which shouldn't be necessary because the filter should only be hand tight! Good luck and remember, if at first you don't succeed ... |
The Following 3 Users Say Thank You to VolvoFan For This Useful Post: |
Apr 29th, 2017, 21:25 | #6 |
Master Member
Last Online: May 28th, 2024 18:49
Join Date: May 2010
Location: wetherby
|
I worked on cars for a living and wish I had a £1 for everyone that I saw overtightened or rubber not lubricated . I use a filter wrench ( bit like a pipe wrench) had it for 30+ years and it has never failed me. All the other suggestions should work. Avoid the screwdriver thing as it may just serve to rip the filter and cause you more issues
__________________
Clive "Lets turn up the juice and see what shakes loose" |
The Following User Says Thank You to CLIVERALLY For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|