|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
V50 2.0D running issueViews : 1401 Replies : 16Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 23rd, 2020, 07:11 | #1 |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
V50 2.0D running issue
Hi I'm hoping someone could help or point me in the right direction.
I've been out in the car yesterday and around 2k rpm and up to 3k rpm the car feels like it has a slight missfire (hard to explain) it feels its struggling but not too much that it will cut out or loses power mainly noticed it in 3rd up to 5th gear if this helps and also after driving I stopped with it running and I'd say after 10 seconds the tick over it feels like the above? Like lumpy... Does this sound like something serious... Other than this it drives fine sets off fine and if you keep your foot down abit changing gears the issue doesn't happen only when driving at them revs really hard to explain so sorry if this is confusing haha |
May 31st, 2020, 17:24 | #2 |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
So and update to the above issue today I was driving and came to a junction set off and give it a little bit 2nd to 3rd then all of a sudden it juddered badly then lost all power and this light came on.. Switched it off and scanned it with a handheld scanner and nothing came up started up and light still showing drove for half a mile all went off and boost / power came back. Also I csn hear like a whistle type of sound when turbo kicks in then it goes.... Anyone have an idea what this could be
|
May 31st, 2020, 18:43 | #3 |
Senior Member
Last Online: Jan 10th, 2024 06:10
Join Date: Jan 2010
Location: West Sussex
|
When was the fuel filter last replaced?
Had an issue with mine once where flooring it in 2nd/3rd gear put it in limp mode with loss of power and engine system service warning message on dash. Changed the fuel filter and all was fine again, but system needs bleeding when changing fuel filter or it won't run at all. |
May 31st, 2020, 20:53 | #4 | |
Junior Member
Last Online: Today 04:49
Join Date: Jul 2011
Location: London
|
Quote:
|
|
May 31st, 2020, 21:30 | #5 | |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
Quote:
I'll double check the service history as only got it in March I've covered 300niles in it meant to have full service history too I might book it in and have this done |
|
May 31st, 2020, 21:31 | #6 |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
|
Jun 1st, 2020, 23:35 | #7 |
Junior Member
Last Online: Today 04:49
Join Date: Jul 2011
Location: London
|
The largest diameter thick-walled rubber hoses at the bottom of the picture (the intercooler is at the front of the vehicle, below the radiator).
|
Jun 2nd, 2020, 01:02 | #8 |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
|
Jun 4th, 2020, 08:50 | #9 |
Junior Member
Last Online: May 3rd, 2024 19:51
Join Date: Jan 2015
Location: Durham
|
Hi baker3570, I too have this ‘misfire at that rev range, I don’t have whistle noise from turbo though, please post back if you manage to fix. Thanks.
|
Jun 5th, 2020, 06:15 | #10 |
Junior Member
Last Online: Apr 5th, 2021 09:28
Join Date: Mar 2020
Location: Barrow-in-Furness
|
|
The Following User Says Thank You to Baker3570 For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|