|
850 / S70 & V70 '96-'99 / C70 '97-'05 General Forum for the 850 and P80-platform 70-series models |
![]() |
|
Replacing fuel filler pipe clampViews : 2130 Replies : 15Users Viewing This Thread : |
![]() |
|
Thread Tools | Display Modes |
![]() |
#11 |
Master Member
Last Online: Today 12:16
Join Date: Jun 2012
Location: Hell
|
![]()
Anybody got a part number?? 🤔
|
![]() |
![]() |
![]() |
#12 |
VOC Member
Last Online: Today 10:39
Join Date: Dec 2001
Location: Hull
|
![]()
I've just ordered a pair of clamps and bolts from my local Volvo dealer. £24 the lot including VOC discount.
Clamp part number: 3531428 M6 Flange bolt part number: 982758 Martin |
![]() |
![]() |
![]() |
#13 |
VOC Member
Last Online: Today 10:39
Join Date: Dec 2001
Location: Hull
|
![]()
I finally got around to fitting the new clamp parts having waited until the tank was nearly empty. One bolt undid fairly easily. It wasn't necessary to undo the other since the bottom clamp plate then simply fell to pieces!
A bit of a clean-up and the new plates went into place very easily. The whole job didn't take more than 15 minutes and I didn't even have to take the wheel off. The marks on the tank aren't leaks but penetrating oil overspray. Definitely one of the easier jobs I've done. Martin 1998 V70 Tdi auto 225,000 miles 2008 V70 2.4D auto 111,000 miles |
![]() |
![]() |
The Following User Says Thank You to Martin Cox For This Useful Post: |
![]() |
#14 |
Master Member
Last Online: Jun 18th, 2024 02:22
Join Date: Aug 2009
Location: Dublin
|
![]()
Well done Martin..Looks a hundred times better..well worth doing
Cheers Vol.
__________________
|
![]() |
![]() |
The Following User Says Thank You to vol For This Useful Post: |
![]() |
#15 |
Master Member
Last Online: Jun 13th, 2024 16:35
Join Date: Nov 2001
Location: Evesham
|
![]()
You need to order two of each of these parts (if ordering from Volvo), otherwise you only get half a clamp and one bolt - as I just discovered.
|
![]() |
![]() |
![]() |
#16 |
Master Member
Last Online: Jun 13th, 2024 16:35
Join Date: Nov 2001
Location: Evesham
|
![]()
I finally got around to fitting this.
It is an easy job. I found it best to first remove the rear RHS wheel. I guess getting the old one off could be a problem, but in my case it was so badly corroded that I could simple pull it off by hand without undoing the thing! |
![]() |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|