|
200 Series General Forum for the Volvo 240 and 260 cars |
Information |
|
warm up reg removalViews : 737 Replies : 6Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Apr 24th, 2011, 17:26 | #1 |
Member
Last Online: Aug 27th, 2012 15:55
Join Date: Aug 2009
Location: derry
|
warm up reg removal
i need to remove the fuel pipes from the warm up reg
but there are on super tight and i dont want to tear them any advise or procedure guidelines |
Apr 24th, 2011, 19:50 | #2 |
Experienced Member
Last Online: Today 00:12
Join Date: Jun 2007
Location: L/H side
|
just undo the 12mm and 14 mm banjo bolts should be easy . You cannot remove the black plastic pipe from the union they are heat shrunk on ...
__________________
My comments are only based on my opinions and vast experience . |
The Following User Says Thank You to Clan For This Useful Post: |
Apr 25th, 2011, 01:30 | #3 |
Member
Last Online: Aug 27th, 2012 15:55
Join Date: Aug 2009
Location: derry
|
done
metal did tear a little as i thought it would but i just held at it now have a nice new shiny utcis-pt component in my engine [IMG] Uploaded with ImageShack.us[/IMG] Last edited by padjoe; Apr 25th, 2011 at 01:32. |
Apr 25th, 2011, 18:36 | #4 |
Member
Last Online: Aug 27th, 2012 15:55
Join Date: Aug 2009
Location: derry
|
Okay any one know which side of ignition coil is the pulse trigger
It should be the neg on older cars which is the red and white wires on the coil Is this correct? |
Apr 25th, 2011, 21:02 | #6 |
Member
Last Online: Aug 27th, 2012 15:55
Join Date: Aug 2009
Location: derry
|
thanks
that means i can start her up tomorrow exciting |
Apr 26th, 2011, 14:43 | #7 |
Member
Last Online: Aug 27th, 2012 15:55
Join Date: Aug 2009
Location: derry
|
Okay ran into a problem the smaller fuel union just turns and turns it will not tighten
Any ideas I hope I didnt bust It |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|