|
S80 '06-'16 / V70 & XC70 '07-'16 General Forum for the P3-platform S80 and 70-series models |
Information |
|
What did you do to your S80/V70/XC70 today?Views : 578321 Replies : 498Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Dec 2nd, 2023, 20:39 | #451 |
Premier Member
Last Online: Today 20:05
Join Date: Apr 2019
Location: Manchester
|
Replaced the glow plugs on my Dad’s V70 yesterday.
On startup, especially as the colder weather has arrived, it used to rumble/shake. There were no lights on the dash, but I hooked up diagnostics and it said there was a fault with the cylinder 2 glow plug. I replaced all 5 glow plugs, as there’s no record of whether they were done before. The old plugs were Bosch, so I replaced them with the same. Now it starts better.
__________________
2007 S80 2.4 D5 (P3) - 110,000 miles 2008 V70 2.4 D5 (P3) - 163,000 miles |
The Following 2 Users Say Thank You to Kev0607 For This Useful Post: |
Dec 3rd, 2023, 23:43 | #452 |
Premier Member
Last Online: Jun 17th, 2024 18:49
Join Date: Dec 2002
Location: Renfrewshire
|
Vida
I rebuilt my laptop from scratch the OS and reload Vida and at last got it all working using Edge browser in compatability mode. Also installed VDash and Forscan for the sacrifice car.
__________________
Tek-Emo Villis Emo Bis V70 SE NAV 1.6 D2 2015MY POWERSHIFT, D4162T, 93000miles, RED. /VOL FCR/PEPER OBD2/Acron 9135 OBD2/L.E.D Flasher/VDASH/ANCEL BA301/Topdon Top Scan |
Dec 4th, 2023, 07:13 | #453 |
The Learner Who Teaches
Last Online: Feb 9th, 2024 12:25
Join Date: Dec 2023
Location: Oklahoma
|
just bought 06 xc70
put in 900 CCA battery because the guy had a 615 in there when he sold me the car without the vent hose plugged in (battery inside back of trunk). Suppose to have 800 atleast for this car and should always be vented due to gases and pressure build. Was showing low power system voltage on scanner. Also, changed oil, filter, and engine filter.
: Last edited by greenz; Dec 4th, 2023 at 07:16. |
Dec 6th, 2023, 17:26 | #454 |
Brit in Germany
Last Online: Jun 19th, 2024 16:10
Join Date: Jan 2011
Location: Bremen
|
Not today, but I sure have been busy!
Firstly, the rear wheel bearings were both making some nasty noises. So, I used the opportunity to replace the rear brakes (discs and pads). OEM SKF wheel bearings, ATE discs and Remsa pads. EPB was done the motor off-retract manually-motor on method. Easy peasy! This was followed by the front axle, which actually was supposed to get new drive shaft boots (split close to the inner tie rods) and wheel bearings as a precaution as the right side brake was binding in the same spot, so before it was a warped hub, it should have been done - while I was at it, but as the lower ball joint didn't want to come undone (joint wouldn't budge), I assembled it all back together, installed new anti roll bar endlinks, new tie rod ends and brakes etc. - was nice knowing my 316 mm discs were the right type, as Volvo seems to have fitted different sizes with the D5... Being 17" rims, it could only be the 300 or 316 mm discs... Again, discs are from ATE, pads from Remsa. Tie rod end and anti roll bar links are Lemförder. The wheel bearings were to be from SKF... So, did all that, my steering wheel was on the ****. I called Volvo and asked if they would fit my parts, especially being OEM parts. Sure! And they included the required alignment and fitting of my new rims and tires (will have to wash my car yet before I can show them ) and did the boots and bearings. Was fun to test a new S60 for the day... Anyhow, after all that, I wanted something inside to look nice. And the result: the automatic shifter looked tired. I wanted some bling and got myself the "chome and charcoal" version... And it turned out really nice!
__________________
The Best Nation Is Imagination 2010 V70 (Type 135) D5 (D5244T10) Automatic (TF-80SC) |
The Following 3 Users Say Thank You to Daim For This Useful Post: |
Dec 10th, 2023, 18:47 | #455 |
Brit in Germany
Last Online: Jun 19th, 2024 16:10
Join Date: Jan 2011
Location: Bremen
|
Gave him a wash as it's basically now all fault free... Though I think I have found one more And the new rims and tires are on. Original Volvo Ixion III from the XC60 in 8x18" with 245/40 R18 (widest tires allowed on the V70) all season Continental AllSeasonContact (had them before, they're good!). Really love the way it came out. Now just needs to be lowered about 20 mm.
__________________
The Best Nation Is Imagination 2010 V70 (Type 135) D5 (D5244T10) Automatic (TF-80SC) |
Dec 11th, 2023, 11:54 | #456 |
Senior Member
Last Online: Yesterday 14:03
Join Date: Feb 2014
Location: Lichfield
|
Changed windscreen washer pump. Easier than expected.
Now contemplating changing boot struts. Last edited by FreshAir; Dec 11th, 2023 at 11:57. |
Dec 16th, 2023, 15:51 | #457 |
Brit in Germany
Last Online: Jun 19th, 2024 16:10
Join Date: Jan 2011
Location: Bremen
|
More stuff done today... Or better yesterday. Changed the upper engine mount, as a compared D5 didn't shift around so much. The mount had also colapsed by 10 mm. So obviously worn. Also the transmission mount was replaced, as that was also rather worn. The rubber diaphragm was full of fluid and also easy to move around, so definitely worth the change.
__________________
The Best Nation Is Imagination 2010 V70 (Type 135) D5 (D5244T10) Automatic (TF-80SC) |
Dec 16th, 2023, 15:57 | #458 |
Premier Member
Last Online: Today 20:05
Join Date: Apr 2019
Location: Manchester
|
Treated my S80 to a wash, wax and dry. I haven't been able to do this for a while because its been raining literally every day. Nice and shiny now.
__________________
2007 S80 2.4 D5 (P3) - 110,000 miles 2008 V70 2.4 D5 (P3) - 163,000 miles |
Dec 29th, 2023, 21:09 | #459 |
Brit in Germany
Last Online: Jun 19th, 2024 16:10
Join Date: Jan 2011
Location: Bremen
|
Replaced the headlights with some new aftermarket ones... Will see how long they last after people have told me they won't last long Before:
Afterwards:
__________________
The Best Nation Is Imagination 2010 V70 (Type 135) D5 (D5244T10) Automatic (TF-80SC) |
The Following User Says Thank You to Daim For This Useful Post: |
Dec 30th, 2023, 02:19 | #460 |
XC70 Owner/VOC Member
Last Online: Apr 8th, 2024 15:07
Join Date: May 2016
Location: Montreal, QC
|
Number (Licence) Plate Light change over
Well, had this issue before on my previous D4, so when I got this car back in October and saw it had a diffy number plate light, I figured the bulb would be away or dirty contacts. If the boot had caught the lume then 9/10 both lights would be off.
I've never liked the OEM number plate lights, quite dull and not very bright. As per the previous XC70 I had, upgraded to LED and they are bright! Before fitting them, gave the light fitting recess a clean out, some WD-40 on the contacts and a light sanding down. The previous light fitting was quite corroded so perhaps a reason it failed due to a poor gasket. Anyway, one small job done and onto the next!
__________________
2012 Volvo XC70 3.0L AWD T6 [CAN🍁] 2015 Volvo XC70 2.4L AWD D4 SE LUX - Sold 78,728 Miles (July 2023) [GB] 2012 Volvo XC70 2.4L AWD D3 SE LUX - Written off 76,500 Miles (Aug 2017)[GB] Last edited by SignumGB; Dec 30th, 2023 at 02:22. |
The Following User Says Thank You to SignumGB For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|