Replacement of Engine Mounts

[lamyewchoy]

Replaced also the engine mounts, following are some pics:
Record thanks to all information on the forums which guides me to complete this job

a) Jack up and support car on stands on firm solid ground
I also remove front rims and the belly pan for better access, since i am also doing other bits undercarriage.
1. Jack and support car - 270909.JPG

b) Need to support and raise engine, so i make a piece of wood with a hole to clear the oil sump plug. This is not a recommended method but i have no access to a proper equipment.
2. Jack and support wood to raise engine to replace engine mount - 270909.JPG

c) This is how i did it. At this stage, just gently support it without raising any further as the engine mounts are still intact
2A. support and jack engine - 270909.JPG

d) Now loosen the top mount screw on the right side. This can be done easily with a long extension rod and a UJ socket driver.
3. unscrew right engine mount top bracket using UJ extension - 270909.JPG

e) Then loosen the one on the left side. This do not require a long extension, but a short one works better. Removing the nut can be done easier with bare hand and a socket.
4. unscrew left engine mount top bracket using short extension - 270909.JPG

f) Then loosen and remove all nuts and screws which secures the lower bracket to the car body. Do not remove the lower mounting screw to the lower bracket.
5. unscrew engine mount lower bracket - 270909.JPG


g) Raise the engine until the top mounting screw is totally out from the top bracket.
6. Jack up engine - 270909.JPG

h) This pic shows the mount is ready to be withdrawn
7. Jack engine till mount top scerw out from top bracket - 270909.JPG

i) Manouvre out the mount
8. manouvre in engine mount - 270909.JPG

j) This is how the mount on the lower bracket looks like
8A. engine mount on lower bracket - 270909.JPG

k) To remove the mount from the lower bracket, i screw it on a piece of wood to have a better grip. Well, maybe a vice is a better solution, but i don't have one
9. screw mount bracket onto wood to secure for uncrewing - 270909.JPG

l) I did it in the drain...
10. unscrew mount from lower bracket, using wood support - 270909.JPG

m) This pic shows the mount taken out
11. engine mount removed - 270909.JPG

For refitting, just do the reverse.