|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
[S40] Anti Skid Temporarily Disabled/offViews : 375 Replies : 3Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 23rd, 2019, 22:39 | #1 |
New Member
Last Online: May 5th, 2021 21:00
Join Date: May 2019
Location: London
|
[S40] Anti Skid Temporarily Disabled/off
First of all hello to everyone!
I recently bought an S40 1.6 Diesel DRIVe 2009 All looks good except when i drive for a while the message in the title pops up. It will go away when i start the car the next day/after a few hours. I've got Vida dice 2014d and got these codes: BCM-0101 BCM-0115 BCM-0148 BCM-E000 Since i don't know for how long they've been there i deleted them today and will see if they will reappear when i drive again. Is this something to be concerned about? I saw a similar thread on google (this forum) with no solution. |
Jun 13th, 2019, 11:12 | #2 |
New Member
Last Online: May 5th, 2021 21:00
Join Date: May 2019
Location: London
|
Ok, i've got an update.
I replaced the EGR valve deleted all the errors and for now there is no problem anymore, no errors drives good. However, after replacing the valve the clamp is not as tight as it was before. I ordered this one https://www.ebay.co.uk/itm/16283J-Ci...72.m2749.l2649 but after installing it it's not as tight either. I can rotate it without much force but won't slip out of place for sure. Is that a problem? |
Jun 13th, 2019, 14:32 | #3 |
Member
|
It shouldn't rotate. It should be darned tight. I reused the old one without problem. Do you have a set of circlip pliers and are you sure the clip is fully done up? It doesn't sound like it.
__________________
Present: 2009 Volvo V50 1.6D DRIVe SE Past: 2004 Volvo S40 T5 SE |
Jun 13th, 2019, 14:50 | #4 |
New Member
Last Online: May 5th, 2021 21:00
Join Date: May 2019
Location: London
|
The first time i removed the old EGR to clean it and put it back in i had no problems with that clamp. I don't have the proper pliers but its snapped in..
Also, the new clamp i bought is using a screw and can't tighten it properly either.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|