|
PV, 120 (Amazon), 1800 General Forum for the Volvo PV, 120 and 1800 cars |
Information |
|
Bosch Blue Coil Wiring in 1964 Amazon WagonViews : 319 Replies : 2Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 20th, 2020, 23:29 | #1 |
Junior Member
Last Online: Mar 24th, 2024 07:40
Join Date: Dec 2019
Location: Newport Beach
|
Bosch Blue Coil Wiring in 1964 Amazon Wagon
This is probably pretty common to most early Volvos, but just wanna get the wiring part correct. I am replacing the ignition switch and coil in my 64 Wagon. Currently there is only one wire going from the coil to the distributor. The power from the ignition switch is currently hard wired with the armored cable. So I am going to replace the ignition switch, run a new wire from the ignition switch to the coil, and then attach the existing wire from the distributor to the coil. So 2 wires is all that should be attached to the new coil, correct?
IMG_2903.jpg Last edited by DaWhole9; Feb 20th, 2020 at 23:35. |
Feb 21st, 2020, 03:11 | #2 |
Premier Member
Last Online: Today 13:32
Join Date: Jul 2007
Location: Connecticut, USA
|
DW9;
Wire it based on info here (without Ballast Resistor): https://www.sw-em.com/Volvo%20Igniti...ce_Information Good Hunting! |
Feb 21st, 2020, 09:12 | #3 |
arcturus
Last Online: Today 07:17
Join Date: Mar 2006
Location: Sagres Portugal
|
I did that last year. Remove core from original coil and insert new
__________________
life's too short to drink bad wine |
The Following User Says Thank You to arcturus For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|