|
850 / S70 & V70 '96-'99 / C70 '97-'05 General Forum for the 850 and P80-platform 70-series models |
Information |
|
Engine management lightViews : 1396 Replies : 5Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Nov 25th, 2002, 10:17 | #1 |
Guest
Location:
|
Engine management light
Hello All,
Does anyone know how to reset the engine management light that appears on the dashboard ? My car was in at the garage last week for an mot and a couple of bits, and one of the mechanics started it from cold then turned it off; which is dosen't like, and would only re-start by taking off an air pipe and cranking it. The engine mgmt light came on because of this pipe been disconnected. The car is running fine and passed it's mot so there are no problems and nothing is stored in the memory but they are having probs in clearing the light. Any suggestions before I go to volvo ??? Cheers, Craig |
Nov 25th, 2002, 20:53 | #2 |
Guest
Location:
|
RE: Engine management light
Depends on what it is.
If its a V70, I've done mine several times different ways. 1 Disconnect battery and reconnect after a minute drawback with this is that you loose all info on computer trips etc 2 Find main fuse link box near windscreen on nearside, remove lid and lift out fuse link nearest widscreen, leave out for minute and refit, this way I kept all the trip info. 850, not sure Keith |
Nov 26th, 2002, 14:19 | #3 |
Guest
Location:
|
RE: Engine management light
It's an 850 ..... anyone else have any wise words ?
|
Nov 26th, 2002, 15:58 | #4 |
VOC Member
Last Online: Apr 10th, 2017 16:55
Join Date: Jan 1970
Location: South Kent Coast
|
RE: Engine management light
Year/model/engine?
|
Nov 26th, 2002, 16:27 | #5 |
Guest
Location:
|
RE: Engine management light
Late 93 (classed as 94 model) 850 SE 2.0 2.0v Est.
Cheers, Craig |
Nov 26th, 2002, 21:11 | #6 |
VOC Member
Last Online: Apr 10th, 2017 16:55
Join Date: Jan 1970
Location: South Kent Coast
|
RE: Engine management light
Use diagnostic sockets behind RH headhamp.
Engine Management codes can be read/reset from connector A2 Use the fly lead from socket A connect to socket A2. Ign. key at pos II. Press button for 1 sec. Read first code. Press button for one sec. again to read further codes, repeat until first code read again. To reset: Hold button down for 5 sec and release, LED should light after short delay. Before the LED goes off press button again for 5 sec. This should reset codes & warning light. Check for codes again, press button for 1 sec, should see code 1-1-1, no faults. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|