|
S40 / V40 '96-'04 General Forum for the Volvo S40 and V40 (Classic) Series from 1995-2004. |
Information |
|
removing a front S40 bumperViews : 927 Replies : 1Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 10th, 2008, 19:08 | #1 |
New Member
Last Online: Feb 13th, 2008 16:24
Join Date: Feb 2007
Location: sunderland
|
removing a front S40 bumper
Hi All,
Any advice on removing a front S40 bumper would be graetly appreciated. I had a bump last night with taxi reversing into me, need to see if the frame is bent? Thanks |
Jan 10th, 2008, 19:45 | #2 |
Master Member
Last Online: Apr 16th, 2021 12:32
Join Date: Aug 2006
Location: Chester
|
Removing and installing front bumpers
Removing the front bumper -Applies only to B4194T or B4204T engines: Remove the covers over the right and left headlamps -Remove the turn signal lamp bulbs on the left and right-hand sides -Remove screw A and the right and left retaining clips for the mudguard -Remove the cable clip B on the front bumper. If applicable: -Disconnect the connectors for the outside temperature sensor, horn and headlamp wipers -Disconnect the washer hose for the headlamp wipers at the T-junction. -Remove the front engine cover under the engine. Disconnect the connectors for the sidemarker lamps. If applicable: -Disconnect the connectors for the fog lamps. Note! If a parking heater is installed, disconnect the power supply connection at the air cleaner (ACL) and disconnect the ground lead for the parking heater. -Remove the 2 clips (A) from the front bumper -Remove the 4 mounting screws for the bumper. If applicable: -Fold the headlamp wiper arms forward. Remove the front bumper assembly. Installing the front bumper If applicable: -Fold the headlamp wiper arms forward -Install the front bumper -Install the 2 clips (A) for the front bumper -Install the 4 mounting screws for the front bumper. Tighten to 40 Nm. -Connect the connectors for the sidemarker lamps -Connect the connectors for the fog lamps if applicable -Install the front engine splash guard under the engine. Note! If a parking heater is installed, connect the power supply connector at the air cleaner (ACL) and connect the ground lead for the parking heater. -Install screw A and the right and left retaining clips for the mudguard -Connect the connectors for the outside temperature sensor, horn and headlamp wipers -Connect the connectors for the turn signal lamps. Reinstall the turn signal lamps -Install the covers over the right and left headlamps. Job Done |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|