|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
C70 2.4 N/A PCV Hose oil filter housing to cyl headViews : 621 Replies : 5Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jul 23rd, 2014, 18:18 | #1 |
New Member
Last Online: Aug 13th, 2014 08:50
Join Date: Jul 2014
Location: aberdeen
|
C70 2.4 N/A PCV Hose oil filter housing to cyl head
Hi folks,
Would appreciate some advice I have a 2006 C70 and have found the PCV hose was cracked upon touching it it fell to bits in my hands or at least the ribbed section did. Couple of questions regarding this, Can you replace this hose on its own and what is approx cost for part? Being normally aspirated can I drive the car until this is fixed low revs to keep pressure down. thanks in advance for any assistance offered. Last edited by megliam; Jul 23rd, 2014 at 19:00. Reason: additional info added |
Jul 23rd, 2014, 18:35 | #2 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
Can you describe where the hose connects to/ from, is it the one out of the top of the cylinder head or somewhere else - There are more than one PCV hose in the system - Mike
|
Jul 23rd, 2014, 18:58 | #3 |
New Member
Last Online: Aug 13th, 2014 08:50
Join Date: Jul 2014
Location: aberdeen
|
Hi Mike,
the hose in question comes from the oil filter housing in behind the inlet manifold and up on to the top of the cylinder head. cheers |
Jul 23rd, 2014, 19:17 | #4 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
You can drive the car with that broken but you might encounter reduced engine performance as the inlet can suck fresh air in via the break in the hose that hasn't been measured by the mass air flow sensor.
Bargain on about £50 for a replacement hose, you will also need to replace the inlet manifold gasket unless you think you can work on the PCV tank connection with the inlet still in place (I would simply pull the inlet manifold for decent access as it makes the job easier) - Mike |
Jul 23rd, 2014, 19:24 | #5 |
New Member
Last Online: Aug 13th, 2014 08:50
Join Date: Jul 2014
Location: aberdeen
|
brilliant, thanks Mike,
This is my first Volvo so can you advise best place to purchase the replacement hose outside dealership cheers |
Jul 23rd, 2014, 19:39 | #6 |
VOC Member
Last Online: Nov 6th, 2016 10:18
Join Date: May 2009
Location: Blackpool UK
|
Get it from the dealer as it is specially shaped to tit the engine without kinking - Mike
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|