|
S60 & V60 '11-'18 / XC60 '09-'17 General Forum for the P3-platform 60-series models |
Information |
|
V60 D5 Rear pad/disk changeViews : 932 Replies : 15Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Sep 13th, 2018, 20:23 | #11 | |
Master Member
Last Online: Dec 29th, 2023 17:48
Join Date: Sep 2011
Location: Thurrock
|
Quote:
Having watched it again I agree with clan. Drive as normal & check back in a few weeks (dependant on usage)
__________________
V60 D5 215 (pre-facelift) Ex-S40 Sport 2.0d with 180bhp & 300lbft |
|
Sep 15th, 2018, 20:41 | #12 | |
Member
Last Online: Mar 20th, 2024 12:05
Join Date: Aug 2017
Location: Herts
|
Quote:
|
|
Sep 15th, 2018, 20:44 | #13 |
Experienced Member
Last Online: Today 00:05
Join Date: Jun 2007
Location: L/H side
|
those rear discs are not new , they have done a lot of miles see the rust around the edge ?
__________________
My comments are only based on my opinions and vast experience . |
Sep 15th, 2018, 20:48 | #14 |
Member
Last Online: Mar 20th, 2024 12:05
Join Date: Aug 2017
Location: Herts
|
Fitted end of July, however excuse the term I used ''recently''.
I wanted to see if the noise dissipated with use, however 2879 miles later it hasn't. I wouldn't lie, I have nothing to gain. |
Sep 15th, 2018, 20:53 | #15 |
Experienced Member
Last Online: Today 00:05
Join Date: Jun 2007
Location: L/H side
|
did you change the pad retaining spring plates which came with the pads ? and cleaned the caliper bracket before fitting if you did ?
__________________
My comments are only based on my opinions and vast experience . |
Sep 16th, 2018, 09:23 | #16 |
Member
Last Online: Mar 20th, 2024 12:05
Join Date: Aug 2017
Location: Herts
|
I cleaned the caliper bracket and fitted the new retaining clips. The pads moved nice and freely with the guides. If it was happening on one side, perhaps its something in my process that has caused this. However both sides replicating the same symptoms points to either the EPB motors or EPB controller if one exists ?
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|