|
300/66 Series General Forum for the Volvo 340, 360 and 66 cars |
Information |
|
360 - Central Locking and Wipers.Views : 1355 Replies : 5Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Dec 4th, 2002, 21:29 | #1 |
Junior Member
Last Online: Jan 6th, 2008 22:20
Join Date: Dec 2001
Location: swansea
|
360 - Central Locking and Wipers.
I have a 360 GLE 1988 2 litre carburettor model and have had problems with the alternator - see separate post on this topic.The day after I replaced the alternator I was on my way into work and suffered some of the same symptoms as when the aletrnator packed in. This was fading lights, fuel and temp guages under reading, and not being able to use headlamps on main beam. The car started on stopping however on the key.
Feeling that I probably had another problem with the electrics that was beyond me, I took it straight to an auto electricians. They found that water was getting in through the drivers side windscreen wiper spindle on the panel just beyond the windscreen and getting into the electrical multi plugs that lie under the dash along side the steering column. Drying the multi plugs has cured the problem but you can see a rusty water trail where the water is coming in. Two questions from this - Has anyone else had this problem and how did you fix it? - I've thought of stripping the wiper arm off and the spindle and putting some silicone around the base of the spindle to stop it leaking but don't really know if I should get in up under the dashboard. Second question is that on return of the car the Cental locking is not working. I've check the fuses and they are OK , but don't know if there is any other protection of the circuit or whether a relay is involved. I suspect that by breaking and making the circuits on the multi plugs that another fault has been introduced and I'll test this my self - but any advice appreciated, because they might have blown a fuse or relay? Apologies again for another long post Thanks Nigel |
Dec 4th, 2002, 23:41 | #2 |
300 Register Keeper
Last Online: Yesterday 09:38
Join Date: Dec 2001
Location: Nottingham
|
RE: 360 - Central Locking and Wipers.
The solenoids go from time to time because water gets into them when the bottom window seals fail (have yours gone brittle and hard?).
One of the annoying quirks - there was a post not so far back by Steve Tames about a supplier for new sealing strip, and I am going to look into this next summer when I next give the car its annual 'going over'! cheers James
__________________
VOC 300-series Register Keeper '13 V70 D4 SE Lux '89 740 Turbo Intercooler '88 360 Turbo Intercooler '84 360 GLT '81 343 GLS R-Sport '79 343 DL '70 164 |
Dec 5th, 2002, 13:54 | #3 |
Member
Last Online: Jun 16th, 2020 17:21
Join Date: Jan 1970
Location: reading
|
RE: 360 - Central Locking and Wipers.
I had that pesky spindle leak when I first got a 340.
I cured it by taking off the wiper arm and putting grease down the spindle and followed by an "o" ring . Check your spindle wear by pushing sideways. If its too worn , this cure may not work but its worth trying! You can also get a leak from the door drain holes into the floor wells if your car is not parked level. good luck, Steve |
Dec 6th, 2002, 18:19 | #4 |
Junior Member
Last Online: Jan 6th, 2008 22:20
Join Date: Dec 2001
Location: swansea
|
RE: 360 - Central Locking and Wipers.
Steve,
Thanks for that - I thought it might be the seal between the spindle boss and the car - the flat plate with the two screws on. Does the spindle assembly strip down to get the grease in the spindle or did you force it in some other way. My Haynes manual doesn't show it broken down into components. Thanks Nigel |
Dec 10th, 2002, 13:52 | #5 |
Member
Last Online: Jun 16th, 2020 17:21
Join Date: Jan 1970
Location: reading
|
RE: 360 - Central Locking and Wipers.
I pushed the spindle sideways to put the LM grease in the gap with a screwdriver blade as its not easy to dismantle . the O ring goes on the spindle to seal it folowed by the wiper blade.
Steve |
Dec 10th, 2002, 20:47 | #6 |
Junior Member
Last Online: Jan 6th, 2008 22:20
Join Date: Dec 2001
Location: swansea
|
RE: 360 - Central Locking and Wipers.
Steve,
Thanks for taking time to reply - I didn't fancy stripping the linkage out from underneath the dash. I'll give it a go. Nigel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|