|
PV, 120 (Amazon), 1800 General Forum for the Volvo PV, 120 and 1800 cars |
Information |
|
Bumper bar attachment, frontViews : 329 Replies : 6Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Mar 11th, 2019, 04:44 | #1 |
Member
Last Online: Mar 1st, 2022 00:17
Join Date: Sep 2018
Location: Mexico City
|
Bumper bar attachment, front
Hi guys,
Does anybody have a picture or drawing of how to attach the front bumper bar in US models. Thank you Andres |
Mar 11th, 2019, 13:41 | #2 |
arcturus
Last Online: Yesterday 08:17
Join Date: Mar 2006
Location: Sagres Portugal
|
Are you talking about the "badge bar" that sits on top of the bumper?
__________________
life's too short to drink bad wine |
Mar 11th, 2019, 13:54 | #3 |
VOC Member
Last Online: Yesterday 15:54
Join Date: Jul 2006
Location: Chatham
|
Front and back. Is this good enough?
|
Mar 11th, 2019, 14:22 | #4 |
Member
Last Online: Mar 1st, 2022 00:17
Join Date: Sep 2018
Location: Mexico City
|
Indeed Arcturus, obrigado
|
Mar 11th, 2019, 14:24 | #5 |
Member
Last Online: Mar 1st, 2022 00:17
Join Date: Sep 2018
Location: Mexico City
|
Thank you Derek, I have the drawing, but it is not clear where it attaches, whn I got my car the bar wasnot attached. Do I assume that goes into the bumper bracket?
|
Mar 11th, 2019, 15:44 | #6 |
VOC Member
Last Online: Yesterday 15:54
Join Date: Jul 2006
Location: Chatham
|
The ends fit using a bolt and washer upwards through the bumper ends I don't know if your bumpers are drilled for them without going back to your first posts. AFAIK the upper mountings go through a hole close to the edge of the wings and are then bolted sideways through the vertical sides of the nose panel. Again I don't know what holes you have there. Depends if this car has had a bar fitted or it has replacement wings. Are yours steel or fibreglass? Top fittings are a long way above the bumper bracket mounts. Strengthen top mount where needed, these are for parking nudge protection only.
|
Mar 11th, 2019, 16:52 | #7 |
Member
Last Online: Mar 1st, 2022 00:17
Join Date: Sep 2018
Location: Mexico City
|
Great advice Derek, I will look carefully at what I have and find the hole positions. Everything is steel.
Sincerely appreciate the help. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|